Bind the pipe joints with two layers of tape.
blank (v) CAP (TN) PUT A CAP ON THE CONNECTOR. Blank connector.
blank off (v) SEAL SEAL THE HOSES. Blank off the hoses.
blank out (v) CANCEL CANCEL THE DISPLAY. Blank out the display.
BLEED (v),
BLEEDS, BLED, BLED To let a gas out of BLEED THE SPEEDBRAKE HYDRAULIC SYSTEM.
blend (v) MIX MIX THE COLORS. Blend the colors.
block (v) CAUSE A BLOCKAGE MAKE SURE THE SEALANT DOES NOT CAUSE A BLOCKAGE OF THE DRAIN. Check sealant does not block drain.
BLOCKAGE (n) That which prevents correct operation MAKE SURE THAT THERE IS NO BLOCKAGE OF THE PITOT PIPE.
BLOCKED (adj) That prevents correct operation A BLOCKED OIL JET CAN CAUSE INCORRECT OPERATION.
blot (v) DRY DRY THE SURFACE WITH A TOWEL. Blot the surface with a towel.
BLOW (v),
BLOWS, BLEW, BLOWN To cause gas to move BLOW DRY AIR THROUGH THE FEED AND SPRAY TUBES.
BLUNT (adj) Not sharp REMOVE THE SEALANT WITH A BLUNT SCRAPER.
blunted (adj) BLUNT EXAMINE THE STATIC DISCHARGERS FOR BENT AND BLUNT PINS. Inspect static dischargers for bent and blunted pins.
bolt (v) BOLT (TN) ATTACH THE TRACK TO THE CHANNELS WITH THE BOLTS. Bolt track to channels.
BOND (n) 1. A connection between structural components for electrical "continuity" DO A RESISTANCE CHECK OF THE PRIMARY BONDS.
2. A connection made with a chemical material THE BOND IS SATISFACTORY AFTER FOUR HOURS.
BOND (v),
BONDS, BONDED, BONDED 1. To make an electrical bond THE STATIC DISCHARGER IS ELECTRICALLY BONDED TO THE WING.
2. To attach items together with a chemical material WHEN YOU BOND THE MATERIALS, APPLY A THIRD COAT OF XXXX.
both (adj) THE TWO (TN) ATTACH THE TWO ENDS OF THE HOSE. Attach both ends of hose.
BOTTOM (adj) That is "lowermost" REMOVE THE BOTTOM BOLT.
BOTTOM (n) The "lowermost" position THE DRAIN PLUG IS AT THE BOTTOM OF THE UNIT.
bottom (v) TOUCH OPEN THE DOOR UNTIL IT TOUCHES THE FLOOR. Open door until it bottoms on the floor.
branch (v) DIVIDE THE PRESSURE LINES DIVIDE IN DIFFERENT DIRECTIONS. The pressure lines branch in different directions.
breadth (n) WIDTH THE WIDTH OF THE MATERIAL MUST BE LARGER THAN XXXX. The breadth of the material must be greater than XXXX.
|
